Outbreak City - How to Build a 28mm Zombie Gaming Table - Part 2

Missed part 1 of this article?

Part 2 of the construction of my All Things Zombie Outbreak City gaming table.

Once I had three identical 2' by 4' battened boards. I lay them side by side and marked the roads and sidewalks.

Measure twice. Draw once. Check, correct and re-draw.

To accommodate tollerances (and my shoddy woodworking) I swapped the boards around as I went, to check that they lined up on every side.

A note on road sizes. I opted for a four inch (10.2 cm) road width, the same approximate size as World Works Games roads, as it strikes a good balance between aesthetics and playability when trying to retain a city-block feel to the table.

Once I was comfortable the measurements I cut to size the second layer sections in 3mm MDF. Being above the level of the roads, this level would represent the sidewalks and hard-standing of the city.

Note: No round corners yets.

I laid out all the sections to check everything was going to fit ok and once I was sure it was within acceptable limits, I cut curves of the top layer into the corners with a jigsaw.

This was also the stage I added a few dropped curbs and cut small notches in the underside of the top layer to represent storm drains. In retrospect, to go the extra mile, I would have cut the storm drains a little deeper and routed small holes in corresponding locations in the sides roads to match.

Finally I fixed the curbs to the base-boards with PVA and, after leaving it to dry for a few days, marked two inch sidewalks onto these sections.

To be continued...

All Things Zombie